When I installed an HVAC plan in my home, I was upset because it seemed the plan was not operational.
I mean, it turned on & it was blowing air, but the air was not cold in the slightest. I also noticed there was a particular code that came up on the indoor HVAC units. I felt really stupid after realizing that I forget a legitimately substantial step, & that’s to release the refrigerant into the HVAC system. So I made sure everything was shut off & released the refrigerant. This was something I should not have forgotten because it was clearly stated in the replacement video not to forget this substantial step. I also l gained that it’s dangerous to run the plan separate from any refrigerant running through the lines. I was kind of concerned about the method that I may have ruined the HVAC plan that I just paid a small fortune for, but luckyly the was ice cold after I opened up the refrigerant lines. It seemed that everything was running with no problems. Even my associate was telling myself and others that it wasn’t likely that I did any damage to my HVAC system. He said I would actually have had to run it for longer than a few seconds to ruin anything with the system. He said if it was a few hours, there might be extreme damage, although I really shut the plan off quickly when I saw the error code on the indoor HVAC units. So far I am enjoying the new ductless mini split, even my energy bills have gone down by a fantastic amount.